Forums

Welp that did the trick! Lol! Can’t believe I didn’t catch that! Thank you very much!

Also, not sure if this applies on the newer boats, but on my ‘16 I make sure I turn the boat on, let the computer do its diagnostics, and then fire it up. Another thing to try is to unplug the battery completely to clear the memory. That has fixed more than one issue for us as well.

Are you turning on the GPS speed control first. I know it sounds dumb but many people have forgotten that step.

So last week our touch screen display unit randomly stopped showing depth and mph. I turned the boat off and back on with the same issue. I then did some digging on here and was recommended to unplug the cable port from under the dash behind the unit. This did the trick once I plugged it back in. However, now the surf right/ surf left tabs do nothing when I select them on the screen. The center trim tab does work. Has anyone ran into this issue or have a solution? Our boat only has 50hrs on it so I’m having a hard time believing the actuators are faulting/water leak and jus

A2Anthony, i also just picked up a 99 210 v drive and my gauges all have power, but the needles point anywhere that doesn't make sense. did you figure out how to get your 4 needle gauge to work right? my tach is hit and miss, my fuel gauge doesn't work (sensor has power and I played with the float, but when i moved it, the needle stayed put), my volt meter works and my temp meter works. Neither speedo works either and the previous owner swapped the pick ups already. i will keep playing with it and post any successes. Hoping I don't have to track down aftermarket gauges.