Boat Discussion
Talk with others about all MB Sports boats
2,920 topics in this forum
-
- 0 replies
- 862 views
-
- 1 reply
- 859 views
-
- 1 reply
- 856 views
-
- 3 replies
- 851 views
-
- 1 reply
- 845 views
-
- 3 replies
- 839 views
-
- 0 replies
- 836 views
-
- 3 replies
- 831 views
-
- 0 replies
- 830 views
-
- 2 replies
- 820 views
-
- 4 replies
- 820 views
-
- 0 replies
- 805 views
-
- 0 replies
- 803 views
-
- 1 reply
- 793 views
-
- 0 replies
- 791 views
-
- 8 replies
- 790 views
-
- 0 replies
- 784 views
-
- 0 replies
- 780 views
-
- 0 replies
- 779 views
-
- 5 replies
- 770 views
-
- 0 replies
- 761 views
-
- 1 reply
- 760 views
-
- 1 reply
- 756 views
-
- 2 replies
- 751 views
-
- 6 replies
- 748 views
-
Recent Activity
-
3
New boat must haves?
Just my 2 cents but at that elevation I wouldn't upgrade the motor. I love my 575 23 Aplha and won't trade it but I boat at 6,000 ft. -
3
New boat must haves?
what brand are those overhead under binimi surf board racks? link? thanks -
0
center tab not function
Dear MB sports, I purchased a 2023 MB B-52 alpha in Feb. 2024. The boat is awesome. However, 15 minutes into our boating experience, the center tab stops working. I am wondering why? it doesn't matter if we are just boating or if we are surfing, the center tab works initially, then completely stops. I have been stuck with the center tab at 30 degrees and at 0 degree. I have to put the boat on the dock lift or trailer for it to reset. Then the next trip out, it does the same thing. advice? -
51
Slappers (KCSO) Part 2 - Installation
I’ve been reading but haven’t found a clear answer. Can you use the factory switch system controller and actuators for slappers? Has anyone done it and did it work well? Thanks I have a 2015 f22 with the gen 2 surf system on it now -
0
Transmission & Motor Mounts
Noticed slight shutter at take off when surfing fully loaded at the end of last season. No sign of shutter at higher speeds or ballast empty. Prop in good condition, dial indicator true in shaft but drive coupling tight at 6 o”clock position. When trying to align the transmission mounts, found 3 bolts holding the mount brackets to the fiberglass stringer are loose and pull out by hand. Are these anchor bolts secured directly in the fiberglass or is there a way to gain access underneath to plate and add nuts? Left message with MB and waiting reply. Thanks! 2019 B52 Raptor- 520 hours
-
