PATRON

2018

Gas shocks and tower locks very different. Can't make new options retro all the time or we would be out of business. 2017 we believe is our best foot forward in all models and equipment improvement

Different hole pattern and location. Plus big $$

Check back of gauge or for possible wire damage

Looks like a direct ground

Call factory and speak with Mike Sanchez. It will be replaced

Should be the Godfather theme song

Same height. This tower is 100 percent billet aluminum structure and is the strongest tower we have offered. Hope to be back in full swing production in about 4 weeks. At one point we had over 50 units on the ground that where finished without towers. Deliveries started approximately 2 weeks ago. When you see it in person I know you will be impressed

I'm in for the steelhead. My son and I do a trip every year on the Trinity River. Fly fishing for stellies is the best

2017 swim step has different corners which would allow slappers without raising step

Who is your dealer and where do you live

A 2249 with .150 cup is a 2247 we have been testing 2249 props with .075 cup to .180 cup.

2249 with .150 cup is perfect for sea level to 3500 feet

Who's your dealer??

My mistake. Uflex is the vendor. This cable is the higher end cable they produce and before fly by wire technology this was the cable of choice at MB

Heavy duty stainless coupling that supports cable and valve ends. Even for our special customers that like to lean on things

Higher end valves were an option but cost was to expensive to justify Valves are being driven by zero friction cables which are best in industry. With higher end valves there was still customer failure so once again simplicity is good. When you see and use in person I promise you will love it

12 degrees primary tab. 0 degree hull bottom

Disconnect wires at transom inside and use a 12 volt cordless drill battery. Software prevents them from deploying for safety reasons. 12 degrees is the magic number

Might be software problem if both parts are acting the same??

Make sure the rudder is greased every 20-30 hours. This way the rudder port will last and not get egg shapped. Use a high pressure grease works best

News to me !!!!!!!!!!!

Rex Marine was pylon vendor at the time

Go faster. 11.5

Our first load of engines with new ratio was in house December 2015