F21slapper

Pulled my gate apart and discovered the motor was toast so i have the internal gear. Tge internal gate teo seals and the factory Carling switch for sale $40 shipped for all No teeth missing on gear

Ill tske it kalen

Interested

2079 still avail?

Bump

Hrr is a pic

Selling the set of boatd racks from my 2011 mb f21 one set of gorks is wske/wake the other set of forks is surf/surf In very good codition $450 plus shipping

Ordered a sweet spot blue and will have Friday. Excited to try it out what should i expect as far as difference from my slingshot board. Tangerine in color

@midnightmax would these replace my actuators

You guys killin me!!!! I would have to say yes on the height for slappers!!! I think over all the boat looks like a new boat! Next year window fram and chrome stuff getting powder caoted. Window tinted and changing ibterior color possibly.....if i dont fall into the 18' 23WB

Yeah the boat does look pretty unreal. But the 18' is looking sweet too!!!!

so if I understand you correct, fill both stock tanks to capacity and add another 300-400 on the surf side plus 300 in the bow. and drain off a lil on the non surf side??

Ok so full on both sides plus another 400 on surfside? And deploy the opposite side gate that you surf on?

This is full left internal ballast and 1/2 of the 1100 sac at 10.2 mph

Here's my 2011 updated with new tower, Bimini, stereo, wrap and gator step all throughout

Hey all, I have a 2011 f21 and looking for advice on getting better wave to surf. I have 1100 extra ballast bag in each rear locker and the boat is slapped by none other than midnight himself. I cannot seem to get the right set up for surfing (small wave with little push ). I've tried lots of combinations now I thought I would ask others who get great waves with similar set what I should be doing? If I need other gear or what have you let me know what your thoughts are. Fwiw I cannot ride without rope, it feels like wave is too short Thanks in advance

Ok thanks guys got it done just gotta wire switch and test it out. Im gonna try to repurpose stock wires so i dont havd to run all new ones

Do you lock gandle in place with the lick ring or no

Going to buy some 4200. Any will prob use switches valtterra supplies and run new wires

Yes but the plunger will hit the wall of the side motor panel. What do I reseal the transom area with from wher I pulled it apart?

The second problem appears to be the Valera valve won't fit in all the way and allow the access cover to be put back on with still being able to use the manual plunger .......thoughts?

Ok so it was pipe on flange. Zero room, I removed from the stainless cover and pulled assembly out from the back, what should I reseal with? 3m 4200. Or silicone?

So I have a 2011 f21 the port side ballast gate will close but not open. The motor sounds like its dying. I've tried lubing, manually opening and closing but no dice. I have bought the Vallerra valve it cannot get the old drain master out. I've loosen all the hose clamps and removed all four bolts. It will spin but I can't get it out. Any help would be appreciated

I have volt meter bud never used. What dobi do and what setting

The face plate was stolen i checken both fuses at switches and both are good