Budman

OrangeTJ, I suspected this to be the case. Appreciate your response.

Great topic and thanks for all the great info. I’ve got a 2015 F24 with a 2247x15x14.25 prop. Top speed about 41 @ 500’ elevation which is fine and not really important to me. But it seems to struggle getting out of the hole with full ballast. Had my boat at the factory for a hull repair and it came back with this new prop mentioned above. I don’t recall what prop I had before but it pulled hard out of the hole with full ballast. Suggestions?

O2 sensors were fine. It was the transmission temp sensor that was unplugged.

Good idea, now I need to find someone local that has one. Sent from my iPad using Tapatalk

Doesn’t go into limp but there is a definite loss of power. I’m leaning towards O2 sensors as well. Two of them, one for each manifold right? Seem simple to change, is there any troubleshooting or computer reset needed? Sent from my iPad using Tapatalk

So, I am having this same issue with the MIL light and beeping. Strainer is clean, engine runs around 165° and the oil level is perfect. Seems like the power is down and I am suspicious of my O2 sensors. Are there easy ways to check them? Or any other advice you guys may have?

Hey MB folks, Took my 2015 F24 out to the lake for the first time this year to shake it down before we go on our big trips. And the engine (Mill?) light flashes and beeps intermittently. Turn the key off for a few minutes and restart it and the beeping and flashing returns after a few minutes. Also seems like the power is down. Oil level good and clean. Sea strainer clean. Runs smooth and quiet, just low on power.....and the beeping and light of course. Ideas and or suggestions? Sent from my iPad using Tapatalk

That looks like an awesome cover! Can you post their contact information please? Sent from my iPad using Tapatalk

For what it's worth, most of the lighting trouble I had with my trailer was all due to poor grounding. Once corrected (for the most part simply by making a solid ground) my lighting has been solid. Sent from my iPhone using Tapatalk

Yes Sent from my iPad using Tapatalk

And the after picture: Detail Sent from my iPhone using Tapatalk

My dealer (California Skier) supplied them from MB. Received them This week and installed yesterday. I'm very impressed! Here are the pics. Before: After: Sent from my iPhone using Tapatalk

The Perfect Pass went out on my 04 and I replaced the speed sensor, lake temp unit. Double check to make sure this is the right one. It's certainly a lot less $$. https://www.bakesonline.com/detail.aspx?ID=1060 Sent from my iPad using Tapatalk

Thanks guys! Sent from my iPad using Tapatalk

Update; MB say they're making brackets and I should have them in another week. I think I have to grind off the old pegs and install the new brackets over the old location. The Bimini poles should now slide into the brackets. Will send pictures once I get them. Sent from my iPad using Tapatalk